EN54
DL-E-AB 06-100/T-EN54 safe
barcode 4 260590 180384

Ceiling speaker for Voice Alarm, A/B-cabling, 2x6 power, certified EN 54-24

Technical Data
Colour RAL 9016
Dimensions 246x66 mm
Ceiling Cut-out 218 mm
Dispersion -6dB, 500Hz single h/v 180° double h/v 180°
Dispersion -6dB, 1KHz single h/v 180° double h/v 180°
Dispersion -6dB, 2KHz single h/v 180° double h/v 77°/137°
Dispersion -6dB, 4KHz single h/v 150°/100° double h/v 33°/90°
Sensitivity EN54-24, 1W/1m 85,0 dB (single) 89,0 dB (double)
Sensitivity EN54-24, 1W/4m 73,0 dB (single) 77,0 dB (double)
Frequency Range 103 - 20.100 Hz (single) 107 - 19.600 Hz (double)
Frequency Response 96 - 23.300 Hz (single) 101 - 22.900 Hz(double)
SPL IEC268-5, 1W/1m 85,0 dB (single) 89,0 dB (double)
SPL EN54-24, Pmax/4m 83,0 dB (single) 88,0 dB (double)
Power 2x6/3/1,5 W
EN54
DL-E-AB 06-100/T-EN54 safe
barcode 4 260590 180384
Mounting Instruction
  1. Create the necessary ceiling cut-out and check the installation depth.
  2. Unscrew the butterfly screw of the contact protection.
  3. Remove the contact protection of the loudspeaker.
  4. Push the incoming cables through the cable entries of the contact protection.
  5. Connect the loudspeaker cable to the terminals 100V and COM.
    If necessary, select a different power tapping.
  6. Place the contact protection back on the loudspeaker and fix it with the butterfly screws.
  7. Fold up the speaker's leg spring and insert the speaker into the ceiling cut-out.
  8. Press the speaker into the ceiling until it is flush with the ceiling cut-out.

Note: To prevent any damage keep the cable lug lock pressed down when changing the cable to a different power tapping.